# Decontamination of 16S data in qiime2

**URL:** <https://forum.qiime2.org/t/decontamination-of-16s-data-in-qiime2/6591>\
**Category:** User Support\
**Created:** [October 24, 2018, 4:22pm UTC](https://forum.qiime2.org/t/decontamination-of-16s-data-in-qiime2/6591 "2018-10-24T16:22:22Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![Nicholas\_Bokulich](https://forum.qiime2.org/user_avatar/forum.qiime2.org/nicholas_bokulich/32/19937_2.png) [@Nicholas\_Bokulich](https://forum.qiime2.org/u/Nicholas_Bokulich)\
**Post date:** [October 24, 2018, 5:15pm UTC](https://forum.qiime2.org/t/decontamination-of-16s-data-in-qiime2/6591/3 "2018-10-24T17:15:50Z")

</div>

Hi @Flutomia,  
See topic for a discussion of various decontamination methods:

> [@Discussion: methods for removing contaminants and cross-talk](https://forum.qiime2.org/t/discussion-methods-for-removing-contaminants-and-cross-talk/5626):
>
> Just to add further to this discussion, I've previously used decontam prior to it being incorporated into QIIME 2, and whilst I'm a huge fan of the principles it's built around, it didn't work fantastically for my samples. I will caveat that as I did only attempt the prevalence method with 2 negative controls (one kit negative and one sequencing negative) for around 20 samples, which is likely too low a number of controls to have any real statistical power, I'm not sure what the ideal number of …

This is a tricky topic and there are no great solutions. For what you describe, it sounds like you could use `qiime feature-table filter-features` or `qiime taxa filter-table` to remove specific features. However, I would not advice this approach. See that discussion thread for more detail but basically there are many reasons why sequences will appear in your negative control, and not all are reagent contamination. If these are cross-contamination from your real samples, "index hopping", or "cross-talk", then they represent sequences that are genuine, true signal in your other samples. Removing them across the board would be bad! Even subtracting a specified number of reads is a bad idea because that assumes that sequence count is closely correlated with biomass. It is not. So I would advice against that approach.

See that discussion... there are some other possible solutions out there. And if you find other software that addresses this problem, please feel free to contribute to that discussion!

I hope that helps!

---

_[View the full topic](https://forum.qiime2.org/t/decontamination-of-16s-data-in-qiime2/6591)._
